Online citations, reference lists, and bibliographies.

The Compressive Behavior Of Bone As A Two-phase Porous Structure.

D. Carter, W. Hayes
Published 1977 · Medicine

Cite This
Download PDF
Analyze on Scholarcy
Compression tests of human and bovine trabecular bone specimens with and without marrow in situ were conducted at strain rates of from 0.001 to 10.0 per second. A porous platen above the specimens allowed the escape of marrow during testing. The presence of marrow increased the strength, modulus, and energy absorption of specimens only at the highest strain rate of 10.0 per second. This enhancement of material properties at the highest strain rate was due primarily to the restricted viscous flow of marrow through the platen rather than the flow through the pores of the trabecular bone. In specimens without marrow, the strength was proportional to the square of the apparent density and the modulus was proportional to the cube of the apparent density. Both strength and modulus were approximately proportional to the strain rate raised to the 0.06 power. These power relationships, which were shown to hold for all bone in the skeleton, allow meaningful predictions of bone tissue strength and stiffness based on in vivo density measurements.

This paper is referenced by
Nanostructured Scaffolds for Bone Tissue Engineering
John C. Igwe (2011)
Microscopic Approach for Testing Mechanical Properties of Hard Tissues
Marica Marrese (2014)
Finite Element Model Construction
Mohammed Rafiq Abdul Kadir (2014)
On the Use of Bone Remodelling Models to Estimate the Density Distribution of Bones. Uniqueness of the Solution
Javier Martínez-Reina (2016)
Mechanical behavior of human bones with different saturation levels
Marcello Cammarata (2016)
Interactive graph-cut segmentation for fast creation of finite element models from clinical ct data for hip fracture prediction
Yves Pauchard (2016)
Development of Cranial Bone Surrogate Structures Using Stereolithographic Additive Manufacturing
Thomas A. Plaisted (2017)
Developmental changes in condylar bone and their mechanical consequences
N.M.B.K. Willems (2012)
A comparative study of 70 cases of inter-trochanteric fracture femur treated with dynamic hip screw and proximal femoral nailing
Gaurav Singla (2017)
Ortho ) “ Comparison of Cutout Resistance of Dynamic Condylar Screw and Proximal Femoral Nail in Reverse Trochantric Fractures ”
USAIM M.Ch. Ortho (2012)
pQCT Assessment at the Radius And Tibia: The Effects of Menopause and Breast Cancer Therapy on Trabecular and Cortical Bone
Kristina Szabo (2009)
A novel approach to finite element analysis of hip fractures due to sideways falls
Oscar Ariza (2014)
Mechanical Therapeutic Effects in Osteoporotic L1-Vertebrae Evaluated by Nonlinear Patient-specific Finite Element Analysis
Daisuke Tawara (2010)
Anatomical Modeling and Rapid Prototyping Assisted Surgical Reconstruction 555
T. Jiang (2000)
Relation between subject-specific hip joint loading, stress distribution in the proximal femur and bone mineral density changes after total hip replacement.
Ilse Jonkers (2008)
Heuristic optimization of bone cement distribution for prevention of osteoporotic hip fractures
María E. Santana Artiles (2016)
Critical analysis on dynamic-mechanical performance of spongy bone: the effect of acrylic cement
D. Ronca (2014)
Finite element analysis of femoral neck stress in relation to pelvic width.
R. Schwarzkopf (2011)
Effects of fluoride treatment on bone strength
D. Carter (1990)
Calcitonin Alters Bone Quality in Beagle Dogs
D. Pienkowski (1997)
An Aetiological Review for the Purposes of Guiding Management
B. Beck (1998)
Finite Element Analysis for Stresses in the Craniofacial Sutures Produced by Maxillary Protraction Forces Applied at the Upper Canines
J. Miyasaka-Hiraga (1994)
Optimal cut of trabecular network.
Z. Tabor (2007)
Three-dimensional finite-element analysis of maxillary protraction with and without rapid palatal expansion.
H. Yu (2007)
Specially adapted interactive tools for an improved 3D-segmentation of the spine.
J. Kaminsky (2004)
A morphological model of vertebral trabecular bone.
H. Kim (2002)
Anatomic and Directional Variation in the Mechanical Properties of the Mandibular Condyle in Pigs
S. Teng (1996)
Three dimensional printed calcium phosphate and poly(caprolactone) composites with improved mechanical properties and preserved microstructure.
Joseph B. Vella (2018)
CHAPTER 2 – The Nature of Osteoporosis
R. Marcus (2008)
Three-dimensional micro-level computational study of Wolff's law via trabecular bone remodeling in the human proximal femur using design space topology optimization.
C. Boyle (2011)
Finite element simulation of bone remodelling in human mandible around osseointegrated dental implant
Zhiqiang Lian (2010)
The role of fabric in the quasi-static compressive mechanical properties of human trabecular bone from various anatomical locations
M. Matsuura (2008)
See more
Semantic Scholar Logo Some data provided by SemanticScholar